#Stereo master mac manual

If this is the case, use COMPUTER AUDIO from the HARDWARE Options. Not all cards will be detected in the HARDWARE options by VirtualDJ, but can still be used. Select SPEAKER+HEADPHONE from the OUTPUT options and the Multi-Channel Soundcard to be used from the HARDWARE options. Always consult the manufacturer's documentation to ensure the proper recommended connections and operation of the SoundCard. In many case the master and headphone outputs will be clearly labeled and the connections will be straightforward. The connections made will be dependant on the manufacturer and the type of interface. Both the speakers and headphones can be connected to the external card. D) MULTI-CHANNEL USB SOUND CARD If an external Multi-Channel USB Soundcard is available, the computerвЂ™s soundcard is not required and can be bypassed. VirtualDJ will then route the Master Output to the 1st stereo channel and Headphones to the 2nd stereo channel of your computerвЂ™s built-in sound card. Select SPEAKER+HEADPHONE in the OUTPUT options and COMPUTER AUDIO from the HARDWARE options.

#Stereo master mac manual

Not all 4.1+ Sound Cards are labeled the same and the sound cardвЂ™s user manual should be referenced in this case. Connect a set of powered speakers into the port marked FRONT and connect the headphones to the port marked REAR. C) INTERNAL STEREO CARD (4.1+) If the computer has a multi-channel stereo soundcard (4.1 or higher) that are mainly found in desktop computers, an additional stereo output is not required to configure the headphone channel. VirtualDJ will then route the Master Output to the 1st stereo channel of your computerвЂ™s built-in sound card and Headphones to the 1st stereo channel of your USB sound card. Select SPEAKER+HEADPHONE in the OUTPUT options and USB SOUNDCARD from the HARDWARE options. Plug the USB Sound Card into an empty USB port and connect the headphones to the appropriate connector on the sound card. A single stereo USB sound card can be used to route the audio out the headphone channel. B) 2 SOUND CARDS If the computer has a single stereo output and an additional stereo output is required for the headphone channel. VirtualDJ will then route the Master Output to the 1st mono channel and Headphones to the 2nd mono channel of the computerвЂ™s built-in sound card. Select SPEAKER+HEADPHONE in the OUTPUT options and STEREO TO MONO SPLITTER from the HARDWARE options. Connect the speakers to one of the ends of the Y-Splitter and connect Headphones to the other. Connect the Y-Splitter cable to the computerвЂ™s sound output (headphone jack). The cable will take a single stereo channel (left & right) and split it into two separate mono channels. A Y-Splitter cable adaptor (Single Stereo to 2 Mono Outputs) can be used in this case. Depending on the hardware available, one of the following and most common configurations will generally be required: A) STEREO TO MONO SPLITTER (Y-CABLE) If the computer has a single stereo output, an additional channel is required to listen to both the Master Output through external speakers and a separate channel through headphones.

There are many different ways to configure a headphone channel. Settings - Audio Setup MASTER & HEADPHONES The default Audio Setup with Master Output is a good starting point but in order to DJ effectively and be able to pre listen (PFL) to the audio before it goes out to the audience, headphones are a necessity.